Duo Cone Seal Installation Process By SAP Parts

Duo Cone / Metal Face Seal should always be installed using the appropriate installation tool.
Duo Cone Seal installation process by SAP Parts-

Step-by-step installation procedure:

1. Align the right duo cone, installation tool, thread-on-fix spray, mallet, and lint-free cloth before starting actual cabinet seal installation.

2. Make sure you are using the appropriate tool part number and design provided by the SAP part for the seal. Note: - There are different tools for each painting. Check Seal faces, o-rings and housings are clean, free from mechanical damage, dents.

3. Attach the Seal-O-Fix to the seal surface and clean the seal using Lint Free Wipe. Clean the surface of the seal thoroughly and make sure there is no microscopic dust. O-rings Spraying around the circumference provides sufficient lubricant for the seals to fit into the cavity of the housing.
Attach the Seal-O-Fix to the seal surface and clean the seal with a Lint-Free Wipe

4. Insert the O-ring into the seal ram and ensure that it is properly fastened to the sleeve. Make sure that the O-Ring is not twisted or twisted.

5. Hold the O-ring on the seal lamp and insert the tool lip between the O-ring gap and seal surface inside the round guide groove on the tool. Hold the o-ring on the seal lamp and tighten the tool lip between the o-ring gap and the seal surface.

6. Firmly fasten the seal to the clamp formed by bringing the edges of the clamp close to each other and tightening the check nut provided on the tool.

7. This will guide you through the installation tool.

Read More - SAP Parts Duo Cone Seals